EasyManua.ls Logo

Mendota FV36 User Manual

Mendota FV36
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
www.mendotahearth.com A Division of Johnson Gas Appliance Company
Installation and Operating Instructions
MODEL NO. FV36 0717 FULLVIEW DIRECT VENT GAS FIREPLACE
HEATER
WARNING: If the information in these instructions
are not followed exactly, a fire or explosion may
result causing property damage, personal injury or
loss of life.
- Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.
- WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier, call
the fire department.
- Installation and service must be performed by a
qualified installer, service agency or the gas supplier.
This appliance may be installed in an aftermarket
permanently located, manufactured home (USA only)
or mobile home, where not prohibited by local
codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is not
convertible for use with other gassed, unless a
certified kit is used.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and shall be installed.
AVERTISSEMENT. Assurez-vous de bien suivre les instructions
données dans cette notice pour réduire au minimum le risque
d'incendie ou d'explosion ou pour éviter tout dommage
matériel, toute blessure ou la mort.
Ne pas entreposer ni utiliser d'essence ni d'autres vapeurs ou
liquids inflammables dans le voisinage de cet appareil ou de
tout autre appareil.
- QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir des
téléphones se trouvant dans le bâtiment où vous vous trouvez.
• Appelez immédiatement votre fournisseur de gaz depuis un
voisin. Suivez les instructions du fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz, appelez le
service des incendies.
- L'installation et l'entretien doivent être assurés par un
installateur ou un service d'entretien qualifié ou par le
fournisseur de gaz.
Cet appareil peut être installé dans une maison préfabriquée
(É.-U. seulement) ou mobile déjà installée à demeure si les
règlements locaux le permettent.
Cet appareil doit être utilisé uniquement avec les types de gaz
indiqués sur la plaque signalétique. Une trousse de conversion
est fournie avec cet appareil.
Une barrière conçue pour réduire le risque de brûlures du verre
chaud est fournie avec cet appareil et doit être installée.

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Mendota FV36 and is the answer not in the manual?

Mendota FV36 Specifications

General IconGeneral
BrandMendota
ModelFV36
CategoryIndoor Fireplace
LanguageEnglish

Summary

General Information

Safety and Warning Information

Comprehensive safety guidelines, installation requirements, and code compliance.

Specific Requirements for Massachusetts

State-specific installation rules for Massachusetts.

Safety and Structural Concerns

Important safety, structural, and installation considerations.

Heating Performance and Aesthetics

Explains heating capabilities and placement guidance.

Manual Gas Shutoff Valve Installation

Requirement for installing a manual gas shutoff valve.

Specifications

General Specifications

Lists overall dimensions, clearances, and system allowances.

Listing Label Information

Information about the product's listing label and its meaning.

Technical Specifications

Details technical aspects like BTUH, orifices, and clearances.

Fireplace and Framing Dimensions

Detailed diagrams of fireplace and required framing dimensions.

Wiring Diagram

Illustration of the fireplace's electrical connections.

Installation

Planning and Installing the Fireplace

Covers planning, framing, and chase construction steps.

Mantel Clearances and Hearth Pads

Guidelines for mantel placement and hearth protection requirements.

Finishing Guides and Materials

Information on framing depth, backing, finishes, paints, and sealants.

Vent System Options and Charts

Venting charts, elbow usage, and through-the-roof installation.

Gas Supply Requirements

Gas Supply Line Sizing

Guidelines for selecting the correct gas line diameter.

Gas Pressure Requirements

Details required gas pressures for proper operation.

Gas Input Rate Verification

Procedures to verify gas input rates and high-altitude derating.

Converting Fireplace for LP Gas

Orifice Sizes and Conversion Procedure

Specifies orifice sizes and provides steps for LP gas conversion.

Pilot Flame and Burner Verification

Checks pilot flame and burner relationship after conversion.

LP Gas Pressure Requirements

Specific pressure requirements for LP gas operation.

Electrical Supply Requirement

AC Power Connection and DC Backup

Instructions for connecting AC power and installing DC backup.

Backup DC Power Inlet Port Installation

Details the installation of the DC backup power system.

Flue Venting Instructions

General Venting Information and Components

Approved vent systems, components, and installation precautions.

Vent Cap Heat Shield and Locations

Instructions for heat shield installation and vent location rules.

Venting Requirements and Configuration

Charts, elbow usage, and notes on venting configuration.

Vertical Through-The-Roof Venting

Instructions for installing a vent system through the roof.

Log Set Installation

Instructions for installing the fireplace log set.

Initial Installer Startup

Startup, Curing, and Odor Elimination

Steps for initial startup, curing smoke, and odors.

Adjusting Flame Appearance

How to adjust air shutters and exhaust damper for optimal flame.

Troubleshooting Flame Appearance

Common flame issues and their corrective actions.

Replacement Parts and Service

Component Access and Maintenance

Guides for accessing parts, pilot maintenance, and general servicing.

Specific Component Details

Details on blowers, accent light, valve assembly, burners, and glass frame.

Replacing Damaged Glass

Step-by-step instructions for replacing the fireplace glass.

Checklists

Installation Checklist

A checklist of items to complete during installation.

Lighting Checklist

A checklist for the initial lighting process.

Homeowner Operation

Welcome and Operation Information

Welcome message and guide to using the remote control.

Remote Control Functions and Settings

Detailed explanation of remote functions, modes, and icons.

IPI and CPI Modes

Explanation of Intermittent and Continuous Pilot Ignition modes.

First-Time Lighting and Troubleshooting

First-Time Lighting Instructions

Step-by-step guide for initial fireplace lighting.

Gas Leak Emergency Procedures

Emergency procedures for gas leaks.

Frequently Asked Questions

Common questions on operation, maintenance, and troubleshooting.

Glass Cleaning and Sooting Issues

Guides for cleaning glass and resolving sooting problems.

Remote Settings and Lockout Reset

Adjusting temperature units, child lock, and resetting lockout.

Warranty and Service Reference

Installer Verification and Owner Registration

Checklists for installers and warranty registration steps.

Mendota Warranty Details

Comprehensive explanation of standard and lifetime warranties.

Related product manuals