66
FV36 85-03-01014
Remote Control Functions
Note: You will hear an audible beep once every time a remote control button is pressed, signaling that the
command has been received.
Locate the four function buttons on the remote control:
1. On/Off Button: This button turns the fireplace on or off. When this button is pressed and the system is
off, the pilot will ignite. After pilot ignition, the pilot will light the main burners. Refer to IPI and CPI
Modes in this manual for pilot ignition.
2. Thermostat Button: This button will allow the selection of three modes: Manual, Normal Thermostat,
and Smart Thermostat.
a. Manual (Off): In this mode, the fireplace can be turned on, regardless of the room temperature. The
actual room temperature has no effect in this mode. All other functions such as fan speed control,
flame height control, secondary burner on/off control and accent light intensity controls are manually
controllable.
Note: The fireplace will automatically shut off after 12
hours of continuous use.
b. Normal Thermostat (On): In this mode, the fireplace will
turn itself on and off, depending on the temperature you
set. When you set the fireplace thermostat, the fireplace
will stay functioning until the room temperature increases
1
o
F above the set thermostat temperature. To increase the
thermostat temperature, press the up button until the
desired temperature is displayed in the thermostat
temperature window. The fan will turn on 5 minutes after
fireplace startup and will turn off 12 ½ minutes after the
flames turn off, in this mode. The flame height can be
adjusted while the fireplace is functioning, fan speed can be adjusted after 5 minutes of startup. Rear
burner can be turned on or off at any time after startup. The accent light can be adjusted any time
after startup.
To Next Page
Loading...
