EasyManua.ls Logo

Mendota FV44i User Manual

Mendota FV44i
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
85-03-01060-M FV44i Décor Gen 3
Installation and Operating Instructions
MODEL NO. AA-11-02969 FV44I Décor Gen 3 FULLVIEW DIRECT VENT GAS FIREPLACE INSERT HEATER
WARNING: If the information in these instructions
is not followed exactly, a fire or explosion may
result causing property damage, personal injury or
loss of life.
AVERTISSEMENT. Assurez-vous de bien suivre les
instructions données dans cette notice pour réduire au
minimum le risque d'incendie ou d'explosion ou pour
éviter tout dommage matériel, toute blessure ou la mort.
- Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.
- WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier, call
the fire department.
- Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
Ne pas entreposer ni utiliser d'essence ni d'autres vapeurs
ou liquids inflammables dans le voisinage de cet appareil
ou de tout autre appareil.
- QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir des
téléphones se trouvant dans le bâtiment où vous trouvez.
• Appelez immédiatement votre fournisseur de gaz depuis
un voisin. Suivez les instructions du fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service des incendies.
- L'installation et l'entretien doivent être assurés par un
installateur ou un service d'entretien qualifié ou par le
fournisseur de gaz.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by local
codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is not
convertible for use with other gasses, unless a
certified kit is used.
Cet appareil peut être installé dans une maison
préfabriquée (É.-U. seulement) ou mobile déjà installée à
demeure si les règlements locaux le permettent.
Cet appareil doit être utilisé uniquement avec les types de
gaz indiqués sur la plaque signalétique. Une trousse de
conversion est fournie avec cet appareil.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and must be installed.
Une barrière conçue pour réduire le risque de brûlures
du verre chaud est fournie avec cet appareil et doit être
installée.

Table of Contents

Other manuals for Mendota FV44i

Questions and Answers:

Mendota FV44i Specifications

General IconGeneral
ModelFV44i
BTU Input (NG)44, 000
Glass TypeCeramic
ControlRemote Control
Vent TypeDirect Vent
Fuel TypeNatural Gas or Propane
IgnitionElectronic
TypeInsert
Efficiency80%
FinishVarious

Summary

READ ME FIRST

INITIAL FIRING AND CURING PROCEDURE

Details the initial heat curing cycle for new materials and paint hardening.

PERIODIC AND ANNUAL CLEANING ARE REQUIRED

Outlines requirements for regular cleaning and maintenance.

GENERAL INFORMATION

SAFETY AND WARNING INFORMATION

Covers building permit, inspection, and other safety cautions.

SAFETY WARNINGS

Provides critical safety warnings, including chemical exposure and installation hazards.

Safety Standards and Warnings

Details specific safety standards for operation and installation.

TECHNICAL REFERENCES

Mendota Fireplace Insert Curing Instructions

Step-by-step guide for the initial curing process.

Install Only in Woodburning fireplaces

Specifies the required installation environment (masonry or ZC fireplaces).

FV44i Insert Ratings Information

Provides technical specifications and ratings for the FV44i Insert.

Normal Surface Temperatures

Discusses normal operating temperatures of surfaces and safety.

Clearances to Combustible Side Walls

Specifies required clearances to combustible side walls.

Clearances to Combustible Mantels

Details clearance requirements for combustible mantels.

Hearth Pad Requirement

Requirements for hearth protection, including R-value and depth.

Venting

Critical instructions for proper venting system installation.

Fireplace and Chimney Cleaning Requirements

Requirements for cleaning the fireplace and chimney before installation.

ELECTRICAL TECHNICAL REFERENCES

Information regarding electrical requirements and connections.

AC Power Requirements

Details the AC power supply needed for the appliance.

AC Power Connection Option

Describes options for connecting AC power to the appliance.

PLUMBING TECHNICAL REFERENCES

Technical details related to gas supply and connections.

Gas Supply Requirements

Outlines requirements for gas pressure and supply line sizing.

Gas Pressure Requirements and Checking

Procedures for checking gas pressure during installation.

Gas Input Rate Verification

Procedures to verify natural gas and LPG input rates.

INSTALLATION INSTRUCTIONS

INSTALLATION CHECKLIST

A step-by-step checklist for completing the installation.

GLASS DOOR REMOVAL AND REINSTALLATION

Procedures for removing and reinstalling the glass door.

NATURAL GAS TO LPG CONVERSION

Information and instructions for converting NG to LPG.

Pressure Regulator Conversion

Steps for converting the pressure regulator for LPG.

FIREPLACE CAVITY PREPARATION

Steps for preparing the fireplace cavity for insert installation.

VENTING

Critical instructions for proper venting system installation.

INSERT BODY INSTALLATION

Steps for sliding the insert body into the fireplace opening.

LIGHTING CHECKLIST

Checklist to ensure proper completion before final operation.

AIR SHUTTER CONTROL AND FLAME APPEARANCE

Adjusting air shutter for optimal flame appearance.

HOMEOWNER INFORMATION

Synchronizing the Fireplace and Remote Control

Steps to synchronize the fireplace with the remote control.

Remote Control Functions

Explains the functions of the remote control buttons.

REMOTE CONTROL OPERATING INSTRUCTIONS

Detailed instructions for operating the remote control.

FIRST TIME LIGHTING INSTRUCTIONS

Step-by-step guide for the initial lighting of the fireplace.

What to do if I smell gas?

Safety instructions if a gas smell is detected.

What maintenance is required?

Overview of required maintenance procedures.

Required Annual Maintenance

Details the annual maintenance tasks to be performed.

MAINTENANCE INFORMATION

REQUIRED ANNUAL MAINTENANCE

Details the annual maintenance procedures.

WARRANTY QUALIFICATION AND SERVICE

FINAL INSTALLATION AND HOMEOWNER CHECKLIST

Checklist for final installation and homeowner information verification.

WARRANTY POLICY STATEMENT

Details the limited lifetime warranty policy for Mendota fireplaces.

Related product manuals