85-03-01060-M FV44i Décor Gen 3 Page 70
standing pilot mode, will operate. When the master switch is in the on-condition, the main burners will
function as designed.
In case of an emergency, toggle the master switch to off to turn off the main burners.
To synchronize the fireplace and remote control, follow the steps below:
1. Toggle the master switch to “on” (toggle up).
2.
Locate sync switch (above master switch in the right-side air gap). Press the sync button and release. The fireplace will beep
three times indicating that it is ready to synchronize with a remote control. (Note: If you do not hear any beeps when you
press the sync button, contact your Mendota dealer or installer for assistance.)
3. Within seven seconds, press the “on” button on the remote control. The fireplace will beep four times to indicate that the
remote control’s command is accepted and sets to the particular code of that controller.
Your system is now initialized.
To Next Page
