85-03-01060 FV44i Décor Gen 3 Page 87
6.7.7 Glass Frame Parts Replacement Procedure
WARNING: do not use substitute materials. All replacement materials must be certified and obtained through
Mendota fireplaces.
TO REPLACE DAMAGED GLASS
1. Bend glass retainer tabs up 90 degrees. Four tabs hold down the glass and gasket assembly.
2. Remove the damaged glass and gasket material. Clean the inner surface of the glass frame.
3. Assemble new gasket on glass edge starting with the bottom left corner. The adhesive on the gasket should contact the
glass surface. Use tracer lines in gasket to determine where the glass should sit on the gasket surface.
4. Place glass and gasket assembly in glass frame and carefully bend down glass retainer tabs. Extra glass retainer tabs are
provided should any originally used tabs break off.
The glass frame assembly and its individual components are available through Johnson Gas Appliance Company. Contact your
dealer for more detailed ordering information.
GLASS FRAME ASSEMBLY REPLACEMENT
1 HA-58-00030
FRAME, WELDMENT, GLASS, FV44i
2 65-02-00103
GASKET, TADPOLE, 5 /8” BULB,
3/4” TAIL, 110”
To Next Page
Loading...
