INSTALLING THE FLOOR LIGHTS
NOTE: This is showing how to install the floor lights in a fireplace that has not been finished and has access to
the front access panels. It is highly recommended to install the floor lights before finishing the fireplace. It will
save a considerable amount of time. The floor lights can still be installed on a finished unit.
Start by making sure that there is no live power running to the fireplace. If there is a floor plate installed in the unit, remove
that now. The old floor will no longer be used, use the floor plate supplied with the floor light kit.
ML54, ML60, and ML72: Next, remove the air channels shown below by removing the (6) screws circled.
To Next Page
Loading...
