Menuett 008164 - Side Brush Maintenance

EN
35
Zigzag vacuum cleaning
Press on the remote control to start zigzag
vacuum cleaning. This mode is mainly used for
quick and eective vacuum cleaning of large
areas without furniture.
FIG. 14
MAINTENANCE
EMPTYING THE DUST CONTAINER
AND CLEANING THE FILTER
Empty the dust container after use.
1. Press
on the casing to open it.
FIG. 15
FIG. 16
2. Take out the dust container.
FIG. 17
3. Take out the HEPA lter.
FIG. 18
4. Take out the primary lter.
FIG. 19
5. Empty the dust container.
FIG. 20
6. Rinse the dust container.
FIG. 21
7. The primary lter should be washed after
15-20 days of use. Rinse the dust and
primary lter with water.
8. The lters can also be cleaned with the
cleaning tool. The maximum life span of
the HEPA lter is 24 months.
FIG. 22
9. Allow the lters to completely dry.
10. Replace the HEPA lter and primary lter
in the dust container.
FIG. 23
11. Close the cover.
NOTE:
Do not expose the lters to direct sunlight.
CLEANING THE SIDE BRUSHES
1. Check if the side brushes are damaged, or
contain any foreign objects.
2. Clean the side brushes with the cleaning
tool or a cloth.
3. Replace the side brushes if they are
damaged and cannot be used. Do as
follows:
– Pull o the old brush.
– Press the new brush on the vacuum
cleaner.
CLEANING THE VACUUM CLEANER
1. Carefully wipe the sensors and wheels
with the cleaning tool or a soft cloth.
FIG. 24
2. Clean the charging terminals on the
charging station with the cleaning tool or
a soft cloth.
FIG. 25
3. Clean the vacuum port with the cleaning
tool or a soft cloth.
FIG. 26