If you need to set static IP address for the Internet port, please follow
these instructions:
1. If you need to assign static IP address, connect to the
router’s local management console using the instructions
in section 2.3.
2. Follow the on-screen instructions to set up a static IP
address.
3. Now connect the Internet port on the router to your ISP
modem or the upstream device that is ultimately
connected to the WAN.
4. On your client machine, connected to one of the LAN
ports, go to http://dashboard.meraki.com.
5. Login to your account and go to the network that you
already created for the new MX60 (see section 2.1).
Confirm that your router is connected to the Dashboard
and that the status is online. If you have a problem, visit
the Meraki online knowledge base at:
http://www.meraki.com/support/.
6. You are now ready to begin monitoring your network
through the Meraki Dashboard.
LAN IP address settings:
These settings let you create a new local subnet that will be served
through the LAN 1 – LAN 4 ports of the MX60.
1. Using a web browser on the client machine (e.g., a
laptop), go to http://dashboard.meraki.com.
2. Login to your account and go to the network that you
already created for the new MX60 (see section 2.1).
Confirm that your router is connected to the Dashboard
and that the status is online.
3. Navigate to “Configure ->Router settings.”
4. Choose “Run NAT only” or “Run a DHCP server and
NAT.”
5. Choose a local subnet base address and subnet mask.
6. Choose an IP address for the MX60. Please note that if
you have chosen “Run a DHCP server and NAT,”
Dashboard will prepopulate the “Router IP” field with a
suitable IP address for the MX60. If necessary, you can
override the IP address with a choice of your own.
7. Set up your DNS servers. You can use settings for Google
DNS, OpenDNS, or provide IPs for custom servers.
8. To test your settings, refresh your laptop / desktop
network settings (e.g., simply disconnect the client device
from the LAN port of the MX60 and then connect it again).
If you have a problem, visit the Meraki online knowledge
base at http://www.meraki.com/support/.
To Next Page
Loading...
