Merax A012C - Page 38

Notes: Restart the machine aer the water plug and drainage cover are installed, otherwise
condensate water of the machine will flow to the floor or the carpet.
Connuous drainage
The self-evaporang system uses the collected water to cool the condenser coils for beer efficient
performance. It is no need to empty the drainage tank in cooling operaon except in drying
operaon and high humidity condions. The condensate water evaporates at the condenser and
evacuated through the exhaust hose.
For connuous operaon or unaended operang in drying operaon, please connect the aached
drain hose to the unit. Condensate water can be automacally flow into a bucket or drain by gravity.
 Switch off the unit before operang.
 Remove the plug of the water outlet opening,
and keep it in safe area.
 Securely and properly connect the drain hose and
make sure it is not kinked and clear of
obstrucon.
 Place the outlet of hose over a drain or bucket
and ensure that water could freely flow out of the
unit.
 Do not submerge the end of hose into water;
otherwise, it can cause "Air Lock" in the hose.
To avoid water spillage:
 As the negave pressure of condensate drain pan is large, lt the drain hose downward
toward the floor. It is appropriate that the degree of inclinaon should exceed 20 degrees.
 Straighten the hose to avoid a trap exisng in the hose.

38