3.3 Selecting the basic vehicle
In order to ensure safe operation of the vehicle, it is
essential to choose the basic vehicle carefully in accor-
dance with the intended use.
⑴ NOTE
The Upfitter must take into consideration the payload
remaining after the conversion when selecting the
basic vehicle, so that it is adequate for the planned
use case typical for the body.
More detailed information on the body variants is
available in chapter3.2Model overview (→page18)
or you can contact the department responsible
(→page14).
ⓘ For further information regarding available option
codes please see the Mercedes-Benz homepage:
www.mbvans.com
eSprinter model series 907
The vehicle can be ordered with a monovalent electric
drive using codes M5E and M9E. The energy supply for
the eSprinter comes from a lithium-ion (Li-ion) battery,
hereinafter referred to as the high-voltage battery,
installed in the underbody. The eSprinter model series
907 is equipped with a rear wheel drive (RWD) and an
automatic transmission with a forward gear, reverse
gear, neutral position and park position.
Body
The body-in-white is virtually identical to that of the
classic Sprinter. The cab, load compartment, and door
apertures for loading are unchanged. One exception is
the underfloor area, where extensive alterations have
been made to the body-in-white for fitting the batterie
and supply lines. Furthermore, other body-in-white
measures protect the components in the event of an
accident.
Mercedes-Benz | Supplemental Guideline for eSprinter – Model Series 907, Edition 2023-8
20
3 Planning of bodies
To Next Page
Loading...
Need help?
General
