1.1 Aim of this Body-Equipment-Guideline
This supplemental guideline, "Supplemental Body and
Equipment Guideline for eSprinter - Model Series 907"
supplements the "Body and Equipment Guideline for
Sprinter - Model Designation 907; Edition MY2023.
⑴ NOTE
This supplemental guideline is based on the develop-
ment of the eSprinter – Model Series907 with rear
wheel drive (electric motor) for the United States and
Canadian markets.
The content of this supplemental guideline applies
exclusively in combination with the aforementioned
Body and Equipment Guideline for Sprinter and only for
the vehicle model designations specified in see chap-
ter3.1 Vehicle and model designation and see chap-
ter3.2 Model overview.
The content described here also applies primarily as
a supplement to the matters in the aforementioned
Body-Equipment-Guideline. The subsections described
here do not replace the subsections of the Body-Equip-
ment-Guideline, but supplement them.
Refer to the Body-Equipment-Guideline for all matters
not described here.
The layout and conventions used in this supplemental
document are the same as those of the Body-Equip-
ment-Guideline.
ⓘ You can find further general information of the
Body-Equipment-Guideline for Sprinter Vans.
1.2 Conventions
ⓘ You can find information on this topic in the chapter
of the same name in the Body-Equipment-Guideline
for Sprinter Vans.
Mercedes-Benz | Supplemental Guideline for eSprinter – Model Series 907, Edition 2023-8
4
1 Introduction
1 Introduction
To Next Page
Loading...
Need help?
General
