Twin co-driver's seat
X
To fold a seat cushion forwards: lift the
seat cushion out of front anchorage :.
X
Pull the seat cushion forwards slightly and
out of rear anchorage ;.
X
Fold the rear edge of the seat cushion up.
i
You can stow various articles in the space
under the twin co-driver's seat.
X
To fold the seat cushion back: fold down
the seat cushion by the rear edge.
X
Slide the seat cushion under the seat back-
rest into rear anchorage ;.
X
Push down on the seat cushion at the front
until it engages in front anchorage :.
Folding seat
G
WARNING
If the key is inserted in the partition sliding
door, it may come into contact with the per-
son on the folding seat. There is a risk of
injury.
Always remove the key from the partition slid-
ing door before a person sits on the folding
seat.
Folding seat (example with partition sliding door)
X
Remove key : from the partition sliding
door.
X
Pull grip ; of the catch in the direction of
the arrow and fold seat cushion = up or
down.
X
Release grip ; of seat cushion = in the
corresponding end position.
X
Move the seat cushion = until it engages.
Grip ; of the catch must lie completely on
the seat frame.
Rear bench seat (Passenger Van)
G
WARNING
If the rear bench seat is not installed as descri-
bed or an unsuitable rear bench seat is instal-
led, the seat belts may not provide protection
as intended. There is an increased risk of
injury.
Install the rear bench seat as described. Only
use rear bench seats that are approved for
your vehicle by the distributor named on the
inside cover page.
!
For safety reasons, the four-seat rear
bench must only be removed or installed at
a qualified specialist workshop.
Keep the seat bench mounting recesses in
the vehicle floor free from dirt and foreign
objects.
Seats
85
Seats, steering wheel and mirrors
Z
To Next Page
Loading...
Need help?
General
