Combination switch
Turn signal lamps
:
To indicate a right turn
;
To indicate a left turn
X
To indicate: press the combination switch
in desired direction : or ; until it
engages.
The combination switch automatically
returns to its original position after large
steering movements.
X
To indicate briefly: press the combination
switch briefly in desired direction :
or ;.
The corresponding turn signal flashes three
times.
High-beam headlamps and high-beam
flasher
:
High-beam headlamps
;
High-beam flasher
X
To switch on the high-beam head-
lamps: switch on the low-beam headlamps
(Y page 93).
X
Press combination switch : forwards.
The K indicator lamp in the instrument
cluster lights up.
i
In the à position, the high-beam head-
lamps are only switched on when it is dark
and the engine is running.
X
To switch off the high-beam head-
lamps: move the combination switch back
to its normal position.
The K indicator lamp in the instrument
cluster goes out.
X
To switch on the high-beam flasher: turn
the SmartKey to position 1 or 2 in the igni-
tion lock.
X
Pull the combination switch briefly in direc-
tion of arrow ;.
Headlamp range adjustment
The headlamp range control is used to adapt
the downward angle of the headlamp beams
in accordance with the load on your vehicle.
The cone of light from the headlamps changes
if seats are occupied or if the cargo compart-
ment is being loaded or unloaded. This can
impair visibility and cause glare to oncoming
traffic.
You can only adjust the headlamp range while
the engine is running.
Exterior lighting
95
Lights and windshield wipers
Z
To Next Page
Loading...
Need help?
General
