Quick start
9
Volumetric Dispensing
Enables a user to auto dispense a pre-selected volume (10mL up to 25L using the custom value).
Note: Make sure there is enough water in the storage tank before dispensing.
The water level in the storage tank is displayed on the right side of the HMI home screen:
Select the volume to dispense, press ok to
validate. The input value can be customized,
go to page 21 Settings > System conguration
Press the Play button to start dispensing the pre-
selected volume.
The system will automatically stop once the requested volume is reached.
Water Quality values
When the dispensing is nished, the resistivity and temperature are instantly displayed on the left
side of the HMI. Ninety seconds later a new TOC value is displayed.
The green LED is lit if the water quality is within specications.
If the calculated TOC value is from 0 to
5 ppb, ≤ 5 ppb will be displayed
If the calculated TOC value is from 6 to 10 ppb,
≤ 10 ppb will be displayed
When TOC values are greater than 10 ppb, then integer values are displayed (example: 13 ppb).
Dispense archiving
After each time a dispensing is done, the water quality values are automatically archived and can be
retrieved in the history report section available in the information menu. Go to page 16 Information >
History for further information.
To Next Page
Loading...
