EasyManuals Logo

MerCruiser 5.7 MPI User Manual

MerCruiser 5.7 MPI
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
Section 6 - Storage
Page 80 90-864197072 NOVEMBER 2007
21125
a
b
c
d
d
Scorpion Models
a - Blue air pump
b - Air manifold
c - Green indicators
d - Blue drain plug locations
8. Verify that water is draining from each opening. If not, use the Three Point Manual
Drain System instructions.
a
6133
b
a - Port side drain location
b - Starboard side drain location
9. Allow the system to drain for a minimum of five minutes. Pump air as necessary to keep
the green indicators extended.
10. Crank the engine over slightly with the starter motor to purge any water trapped in the
seawater pump. Do not allow engine to start.
11. Reinstall the blue drain plug in the thermostat housing or heat exchanger.
12. Remove the air pump from the air manifold and return it to the mounting bracket.
13. Mercury MerCruiser recommends leaving the drain system open while transporting the
boat or while performing other maintenance. This helps ensure that all water is drained.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MerCruiser 5.7 MPI and is the answer not in the manual?

MerCruiser 5.7 MPI Specifications

General IconGeneral
Engine TypeV8
Fuel SystemMulti-Port Fuel Injection (MPI)
Horsepower300 HP
IgnitionElectronic
Cylinders8
Fuel TypeGasoline
Alternator65 amp
Compression Ratio9.4:1
Fuel Requirement87 octane (minimum)
Displacement5.7L (350 cu in)
Max RPM5000 RPM

Related product manuals