Mercury 100 FourStroke User Manual

2. Remove the vent plug/sealing washer.
3. Remove the fill/drain plug. Place the lubricant tube into the fill hole and
add the lubricant until it appears at the vent hole.
a - Vent hole
b - Fill hole
IMPORTANT: Replace the sealing washers if damaged.
4. Stop adding the lubricant. Install the vent plug and sealing washer before
removing the lubricant tube.
5. Remove the lubricant tube and install cleaned fill/drain plug and sealing
washer.
a
b
22693
MAINTENANCE
eng 87

Mercury 100 FourStroke Specifications

General

Brand	Mercury
Model	100 FourStroke
Category	Outboard Motor
Language	English