EasyManuals Logo

Mercury 135 Optimax Operation And Maintenance Manual

Mercury 135 Optimax
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
MAINTENANCE
46
Description Nm lb. in. lb. ft.
Spark plug 27 20
Compressor Air Intake Filter
The filter should be changed every 100 hours of operation, or once a season.
IMPORTANT: Never run the engine without the air filter.
REMOVAL
1. Remove flywheel cover from engine.
2. Snap out the retainer and remove filter.
ob01559
a
b
a - Retainer b - Filter
INSTALLATION
1. Install filter into cover.
2. Secure filter into cover with retainer.
Alternator Belt Inspection
1. Inspect the alternator belt and have it replaced by an authorized dealer if any of the following conditions are
found.
a. Cracks or deterioration in the rubber portion of the belt.
b. Belt surfaces rough or uneven.
c. Signs of wear on edges or outer surfaces of belt.

Table of Contents

Other manuals for Mercury 135 Optimax

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 135 Optimax and is the answer not in the manual?

Mercury 135 Optimax Specifications

General IconGeneral
StartingElectric
ExhaustThrough Prop
Horsepower135 HP
Fuel Induction SystemDirect Fuel Injection
Alternator Amp60 Amp
Shaft Length20", 25"
Full Throttle RPM5250-5750
SteeringHydraulic

Related product manuals