OPERATION
94
NOTE: For initial start of a new engine or for an engine that ran
out of fuel or was drained of fuel, the fuel system should be filled
as follows:
Turn the ignition key switch to the "ON" position for approximately
one minute. This operates the fuel lift pump. Turn the ignition key
switch back to the "OFF" position and then return the ignition key
switch to the "ON" position again for an additional minute. Turn
the ignition key switch back to the "OFF" position. The filling of the
fuel system is complete.
6. Ignition key starting - Turn the ignition key to "START" position
and release the key. The electronic starting system will
automatically crank the engine for starting. If the engine fails
to start, the engine will stop cranking. Turn the key to "START"
position again until engine starts.
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
3485
7. After engine starts, check for a steady stream of water flowing
out of the water pump indicator hole.
IMPORTANT: If no water is coming out of the water pump
indicator hole, stop engine and check the cooling water intake for
obstruction. No obstruction may indicate a water pump failure or
blockage in the cooling system. These conditions will cause the
engine to overheat. Have the outboard checked by your dealer.
Operating the engine while overheated will cause engine damage.
To Next Page
Loading...
Need help?
General
