FEATURES AND CONTROLS
45
NOTE: The active light on the remote control will be illuminated at
the helm that is in control of the engine.
The helm transfer function allows the boat operator to select which
helm is in control of engine operation. Pressing the throttle only/
station select button two times allows engine control to be
transferred to a new helm. When a helm transfer is initiated, the
control will automatically start adjusting engine RPM and gear
position to match the control handle setting at the new helm. Adjust
the control handles to the desired throttle and gear position.
NOTE: There is a 10 second time frame to complete a helm
transfer. If the helm transfer is not completed, the action will be
cancelled and a double beep will sound. Pressing the throttle only/
station select button again will re-initiate a helm transfer.
1. Place active remote control lever to idle position.
2. Proceed to the inactive helm and position remote control lever
to the idle position.
3. Press throttle only/station select button two times. The
"ACTIVE" light will illuminate to indicate the remote control is
in control of the engine.
To Next Page
Loading...
Need help?
General
