4. Pull propeller straight off the shaft. If the propeller is seized to the shaft
and cannot be removed, have the propeller removed by an authorized
dealer.
5. To aid in future removal of the propeller, liberally coat the propeller shaft
splines with one of the following Mercury/Quicksilver products:
Tube Ref
No.
Description Where Used Part No.
Extreme Grease Propeller shaft splines 8M0071842
95
2-4-C with PTFE Propeller shaft splines 92-802859A 1
FLO-TORQ III AND IV PROPELLERS
1. Lubricate the propeller shaft with one of the following.
Tube Ref
No.
Description Where Used Part No.
Extreme Grease Propeller shaft splines 8M0071842
95
2-4-C with PTFE Propeller shaft splines 92-802859A 1
2. Install the propeller onto the shaft as shown. If the components supplied
with the propeller are different than what is shown, refer to the propeller
installation instructions provided with your product or contact your dealer.
3. Place a block of wood between the gearcase and the propeller.
4. Tighten the locknut to the specified torque.
MAINTENANCE
eng 99
To Next Page
Loading...
