OPERATION
95
4. Set the lanyard stop switch to the "RUN" position. Refer to
General Information - Lanyard Stop Switch.
5. Shift outboard to neutral (N) position.
F
N
R
3413
F
N
R
3417
NOTE: For initial start of a new engine or for an engine that ran
out of fuel or was drained of fuel, the fuel system should be filled
as follows:
Turn the ignition key switch to the "ON" position for approximately
one minute. This operates the fuel lift pump. Turn the ignition key
switch back to the "OFF" position and then return the ignition key
switch to the "ON" position again for an additional minute. Turn
the ignition key switch back to the "OFF" position. The filling of the
fuel system is complete.
To Next Page
Loading...
