MAINTENANCE
eng 107
6. Coat the propeller shaft with Quicksilver or Mercury
Precision Lubricants Anti‑Corrosion Grease or 2‑4‑C with
PTFE.
Tube
Ref No.
Description Where Used Part No.
94
Anti-Corrosion
Grease
Propeller shaft 92-802867Q 1
95
2-4-C with
PTFE
Propeller shaft 92-802859A 1
7. Install front thrust hub, propeller, rear thrust hub washer and
propeller nut onto the shaft.
a - Propeller nut
b - Rear thrust washer
c - Propeller
d - Forward thrust hub
8. Place a block of wood between gearcase and propeller and
torque propeller nut to specification.
NOTE: If the propeller nut does not align with the propeller shaft
hole after tightening to the specified torque, then tighten the nut
further to align it with the hole.
To Next Page
Loading...
