INSTALLATION
150 eng
2. Remove spark plug leads to prevent engine from starting.
3. Coat the propeller shaft with Anti‑Corrosion Grease or 2‑4‑C
with PTFE.
IMPORTANT: To prevent the propeller hub from corroding and
seizing to the propeller shaft (especially in salt water), always
apply a coat of the recommended lubricant to the entire
propeller shaft at the recommended maintenance intervals and
also each time the propeller is removed.
Tube
Ref No.
Description Where Used Part No.
94
Anti-Corrosion
Grease
Propeller shaft 92-802867Q 1
95
2-4-C with
PTFE
Propeller shaft 92-802859A 1
4. Install front thrust hub, propeller, rear thrust washer and
propeller nut onto the shaft.
a - Propeller nut
b - Rear thrust washer
c - Propeller
d - Forward thrust hub
5. Place a block of wood between gearcase and propeller and
torque propeller nut to specification.
To Next Page
Loading...
