FEATURES AND CONTROLS
eng 63
Warning System
Function Sound
Warning
Light
Description
Engine
Speed
Limited to
2800
RPM
Start up One beep
On for 5
seconds
Normal system
test
Engine over
temperature
Continuous On Engine overheat X
Low oil pressure Continuous On Low oil pressure X
Engine
overspeed
Continuous On
Engine speed
exceeds
maximum
allowable RPM
Water temp or
MAP sensor out
of range
Intermittent
short beep
Flashes
Engine speed
will be limited.
Consult your
dealer for
assistance.
X
ENGINE OVERHEAT
If the engine overheats, immediately reduce throttle speed to
idle. Shift outboard into neutral and check for a steady stream of
water coming out of the water pump indicator hole.
If no water is coming out of the water pump indicator hole, or
flow is intermittent, stop engine and check cooling water intake
holes for obstruction. If no obstruction is found, this may indicate
a blockage in the cooling system or a water pump problem. Have
the outboard checked by your dealer. Operating the engine while
overheated will cause engine damage.
To Next Page
Loading...
Need help?
General
