4. Push in on the fuel hose release tabs and disconnect the fuel hoses from
the fuel filter.
5. Disconnect the water‑in‑fuel sensor harness.
NOTE: If there is a boat mounted water‑separating fuel filter with a
water‑in‑fuel sensor installed, the sensor harness would be connected to the
boat mounted filter.
a - Fuel hose release tabs
b - Water‑in‑fuel sensor harness
6. Rotate the filter clockwise approximately 1/4 of a turn and lift the filter out.
Filter rotated 1/4 turn
7. Empty the fuel filter contents into an approved container and dispose
according to local regulations.
To Next Page
Loading...
Need help?
General
