Protecting Internal Engine Components
IMPORTANT: Refer to Maintenance ‑ Spark Plug Inspection and Replacement
for correct procedure for removing spark plugs.
• Remove the high tension spark plug leads and spark plugs.
• Spray approximately 30 ml (1 fl oz) of Storage Seal Rust Inhibitor into
each spark plug hole.
Tube Ref
No.
Description Where Used Part No.
119
Storage Seal Rust
Inhibitor
Spark plug holes 92-858081K03
• Actuate key/push button start switch to crank the engine through one start
cycle, which will distribute the storage seal throughout the cylinders.
• Install spark plugs and the high tension spark plug leads.
Gearcase
•
Drain and refill the gearcase lubricant. Refer to Gearcase Lubrication.
Positioning Outboard for Storage
Store outboard in an upright (vertical) position to allow water to drain out of the
outboard.
NOTICE
Storing the outboard in a tilted position can damage the outboard. Water
trapped in the cooling passages or rain water collected in the propeller
exhaust outlet in the gearcase can freeze. Store the outboard in the full down
position.
Battery Storage
• Follow the battery manufacturer's instructions for storage and charging.
• Remove the battery from the boat and check water level. Charge if
necessary.
• Store the battery in a cool, dry place.
• Periodically check the water level and charge the battery during storage.
STORAGE
82 eng
To Next Page
Loading...
