Section 5 - Maintenance
Page 92 90-8M0050539 eng MAY 2011
10. Continue to pump gear lubricant into the drive through the oil fill and drain hole until gear lubricant appears in the gear lube
monitor.
11. Fill the monitor so that the oil level is in the operating range. Do not overfill.
12. Ensure that the rubber gasket is inside the cap and install. Do not overtighten.
NOTE: Oil capacities include the gear lube monitor.
Model Capacity Fluid Type
Bravo One 2736 ml (92‑1/2 oz.)
High Performance Gear Lubricant
Bravo Two 3209 ml (108‑1/2 oz.)
Bravo Three (Single seawater pickup) 2972 ml (100‑1/2 oz.)
Bravo Three (Dual seawater pickup) 2736 ml (92‑1/2 oz.)
13. Remove the pump from the oil fill and drain hole. Quickly install the sealing washer and screw. Tighten securely.
14. Reinstall the propeller. Refer to Propellers.
15. Check the oil level after the first use.
IMPORTANT: Oil level in the gear lube monitor rises and falls during operation. Always check the oil level when the sterndrive is
cool and the engine is off.
Power Trim Fluid
Checking
IMPORTANT: Check the oil level with the sterndrive unit in the full down/in position only.
1. Place the sterndrive unit in full down/in position.
2. Observe the oil level. Level must be between the "MIN" and "MAX" lines on the reservoir.
a - Reservoir
b - "MIN" and "MAX" lines
3. Fill as necessary with the specified fluid.
Tube Ref No. Description Where Used Part No.
114
Power Trim and Steering
Fluid
Power trim pump 92-858074K01
Filling
1. Remove the fill cap from the reservoir.
NOTE: Fill cap is vented.
2. Add lubricant to bring level to the within the "MIN" and "MAX" lines on the reservoir.
Tube Ref No.
Description Where Used Part No.
114
Power Trim and Steering
Fluid
Power trim pump 92-858074K01
3. Install the cap.
a
b
7876
To Next Page
Loading...
