Section 6 - Storage
90-8M0050539 eng MAY 2011 Page 145
Multi‑Point Drain (MPD) System
1. Place the boat on a level surface to ensure complete draining of the system.
2. Remove the blue drain plugs from the following locations. It may be necessary to clean out the drain holes using a stiff piece
of wire. Do no until the entire system is drained.
a. Port and starboard side of cylinder block
b. Bottom of exhaust manifolds
a - Cylinder block drain plug
b - Exhaust manifold drain
plug
c. Water circulating pump hose
a - Drain plug
d. Fuel cooler to thermostat housing hose
a - Drain plug
10226
M110050
93235672
b
a
a
b
6129
a
6143
a
6144
To Next Page
Loading...
