Mercury 350 MAG - Bravo Transom Serial Number; Lanyard Stop Switch

Section 2 - Getting to Know Your Power Package
Page 24 90-8M0050539 eng MAY 2011
Bravo Transom Serial Number
The Bravo transom serial number is stamped in the U‑bolt plate of the Bravo transom assembly.
Bravo transom assembly U-bolt plate
a - Transom assembly serial Number
The serial number is also stamped on the gimbal housing. This is used as a permanent reference for authorized MerCruiser
Dealers.
Gimbal housing with serial
number stamping
a - Transom assembly serial
Number
Lanyard Stop Switch
The purpose of a lanyard stop switch is to turn off the engine when the operator moves outside the operator's position (as in
accidental ejection from the operator's position).
a - Stop switch
b - Lanyard
c - Clips to the operator
Accidental ejections, such as falling overboard, are more likely to occur in:
• low‑sided sport boats
• bass boats
• high performance boats
Accidental ejections can also occur from:
• poor operating practices
25904
a
25905
a
74608
RUN
a
b
c