Mercury 350 MAG - Page 108

Section 5 - Maintenance
Page 100 90-8M0050539 eng MAY 2011
1. If Steering Cable Has Grease Fittings: Turn steering wheel until steering cable is fully retracted into cable housing. Apply
approximately 3 pumps of grease from a typical hand‑operated grease gun.
a - Steering cable grease fitting
Tube Ref No. Description Where Used Part No.
34
Special Lubricant 101 Steering cable grease fitting 92-802865Q02
2. Turn steering wheel until steering cable fully extended. Lightly lubricate the exposed part of cable.
a - Extended steering cable
Tube Ref No. Description Where Used Part No.
34
Special Lubricant 101 Steering cable 92-802865Q02
3. Lubricate the steering pin.
a - Steering pin
Tube Ref. No. Description Where Used Part No.
Synthetic Blend MerCruiser Engine Oil
SAE25W‑40
Steering pin 92‑883725K01
4. On dual engine boats: Lubricate the tie bar pivot points.
6221
a
a
6222
mc71904-1
a