Section 9 - Checklists
90-8M0050539 eng MAY 2011 Page 161
Predelivery Inspection Checklist, Continued
N/A
Check/
Adjust
Item
On-the-Water Test
Engine alignment (Inboard models only)
Starter neutral safety switch operation
E‑stop switch/lanyard stop switch operation (all helms)
Seawater pump operation
Operation of instruments
Fuel, oil, and water leaks
Exhaust leaks
Ignition timing
Forward, neutral, and reverse gear operation
Steering operation throughout range
Acceleration from idle RPM is normal
WOT________ RPM within specification (in forward gear)
EC models: run two full operating cycles (key on/off) to WOT with engine at normal operating temperature while
monitoring engine with G3 CDS to verify engine goes into closed‑loop engine control.
Power trim operation
Boat handling
After On-the-Water Test
Propeller nut tightened to specification
Fuel, oil, coolant, water and fluid leaks
Oil and fluid levels
Apply Quicksilver Corrosion Guard to engine package
Operation, Maintenance & Warranty manual in boat
If Boat Is Registered to a Resident of California
CARB hang tag in boat
CARB decal properly affixed to boat hull
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
To Next Page
Loading...
