Section 4 - Maintenance
90-8M0113987 eng DECEMBER 2015 Page 93
Power‑assisted steering drive belt tension
Belt deflection, with moderate hand pressure 5 mm (3/16 in.)
3. Torque the power‑assisted steering pump mounting and tensioning flange bolts.
2.8 shown, 4.2 similar
a - Mounting bolts
Description Nm lb. in. lb. ft.
Power‑assisted steering pump mounting bolts 21 15
Replacement
1.
Remove the serpentine belt. See Serpentine Belt.
2. Loosen the power‑assisted steering pump mounting bolts.
2.8 shown, 4.2 similar
a - Mounting bolts
3. Loosen the existing power‑assisted steering pump belt by turning the adjustment screw counterclockwise.
a - Mounting bolts
b - Adjustment screw
4. Remove the existing power‑assisted steering pump belt.
5. Install the new power‑assisted steering pump belt.
To Next Page
Loading...
