Section 4 - Maintenance
Page 54 90-8M0113987 eng DECEMBER 2015
Installation
1. Slide the filter element into the air filter housing. Ensure that the element is seated fully into the air filter housing.
a - Air filter housing
b - Air filter element
NOTE: The warning labels on the air filter housing must be visible after the air filter housing is installed.
2. Install the air filter housing on to the turbocharger inlet.
3. Torque the air filter housing clamp.
Description
Nm lb. in. lb. ft.
Air filter housing clamp 3.4–6.8 30–60
4. Install the oil separator vent house. Tighten the oil separator vent hose clamp securely.
a - Oil separator vent hose
b - Air filter housing
c - Turbocharger
d - Clamp
Water‑Separating Fuel Filter
!
WARNING
Fuel is flammable and explosive. Ensure that the key switch is off and the lanyard is positioned so that the engine cannot
start. Do not smoke or allow sources of spark or open flame in the area while servicing. Keep the work area well ventilated
and avoid prolonged exposure to vapors. Always check for leaks before attempting to start the engine, and wipe up any
spilled fuel immediately.
NOTICE
Water entering the fuel injection system will cause corrosion and rusting of the injectors and other components, disabling the
fuel injection system. Check daily for water in the water‑separating fuel filter and have the engine inspected immediately if
there is evidence of water in the fuel system.
IMPORTANT: Use a suitable container to collect fuel. Clean up any spills immediately and dispose of fuel in a safe manner in
accordance with all local, federal, and international regulations.
To Next Page
Loading...
