Section 4 - Maintenance
Page 82 90-8M0113987 eng DECEMBER 2015
Transom Assembly
Lubricate the gimbal bearing by applying approximately 8‑10 pumps of grease from a typical hand‑operated grease gun.
a - Gimbal bearing grease insert
Tube Ref No. Description Where Used Part No.
Extreme Grease Gimbal bearing grease insert 8M0071842
Engine Coupler
IMPORTANT: These engines are equipped with a sealed engine coupler. The sealed coupler and the shaft splines can be
lubricated without removing the sterndrive.
Lubricate the engine coupler splines through the grease fitting on the coupler by applying approximately 8–10 pumps of
Extreme Grease from a typical hand‑operated grease gun.
NOTE: If the boat is operated at idle for prolonged periods of time, the coupler should be lubricated on Bravo models every 50
hours.
a - Grease fitting
b - Coupler splines
Tube Ref No. Description Where Used Part No.
Extreme Grease Engine coupler and shaft splines 8M0071842
Driveshaft Extension Models
1. Lubricate the transom end grease fitting and engine end grease fitting by applying approximately 10–12 pumps of grease
from a typical hand‑operated grease gun.
a
19979
To Next Page
Loading...
