44
Gas Sterndrive (Continued)
Scheduled Maintenance *
Annu-
ally
Every
100
Hours or
Annually
z
Every
200
Hours
or 3
Years
z
Every
300
Hours
or 3
Years
z
Every
2
Years
Every
5
Years
Touch-up paint power package and spray with corrosion
guard.
L
Change crankcase oil and filter. L
Change drive unit oil and retorque connection of gimbal
ring to steering shaft.
L
Replace fuel filter. L
Check steering system and remote control for loose,
missing or damaged parts. Lubricate cables and
linkages.
L
Inspect and lubricate U-joints and splines; inspect bel-
lows and clamps. Check engine alignment.
L
Lubricate gimbal bearing and engine coupler. L*
Check continuity circuit for loose or damaged connec-
tions. Test MerCathodeR unit output on Bravo models.
L
Retorque engine mounts. L
Check spark plugs, wires, distributor cap and ignition tim-
ing. Check and adjust idle speed.
L
Clean flame arrestor. L
Check electrical system for loose, damaged or corroded
fasteners.
L
Inspect condition and tension of belts. L
Check cooling system and exhaust system hose clamps
for tightness. Inspect both systems for damage or leaks.
L
Disassemble and inspect seawater pump and replace
worn components.
L
Clean seawater section of closed cooling system. Clean,
inspect and test pressure cap.
L
Replace coolant. L
Lubricate driveshaft U-joints and tailstock input and out-
put bearings.
L
* Only perform maintenance which applies to your particular power package
z Whichever Occurs First
* Lubricate engine coupler every 50 hours if operated at idle for prolonged periods of time.
To Next Page
Loading...
