EasyManua.ls Logo

Mercury 496 MAG Bravo - Cold Weather And Extended Storage

Mercury 496 MAG Bravo
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
67
CB838
Cold Weather And Extended Storage
IMPORTANT: Mercury MerCruiser strongly recommends that this service should be performed by an
authorized Mercury MerCruiser dealer. Damage caused by freezing IS NOT
covered by the Mercury Mer-
Cruiser Limited Warranty.
CAUTION
Sterndrive unit should be stored in the full DOWN position. Universal joint bellows may develop a set
if unit is stored in raised position and may fail when unit is returned to service.
IMPORTANT: Mercury MerCruiser recommends that propylene glycol antifreeze (a nontoxic and envi-
ronmentally safe antifreeze) be used in the seawater section of the cooling system for cold weather or
extended storage. Ensure that the propylene glycol antifreeze contains a rust inhibitor and is recom-
mended for use in marine engines. Be certain to follow the propylene glycol manufacturers recommen-
dations.
CAUTION
The seawater section of the cooling system MUST BE COMPLETELY drained for winter storage, or im-
mediately after cold weather use, if the possibility of freezing temperatures exist. Failure to comply
may result in trapped water causing freeze and/or corrosion damage to the engine. Damage caused
by freezing is NOT covered by the Mercury MerCruiser Limited Warranty.
Preparing Your Power Package For Storage
1 Fill the fuel tanks with fresh gasoline (that does not contain alcohol) and a sufficient amount of Mercury Fuel
System Treatment and Stabilizer to treat the gasoline. Follow instructions on the container.
2 If the boat is to be placed in storage with fuel containing alcohol in fuel tanks (if fuel without alcohol
is not available): Fuel tanks should be drained as low as possible and Quicksilver Gasoline Stabilizer for
Marine Engines added to any fuel remaining in the tank.
NOTE: If desired, a portable fuel tank can be used to perform the remainder of the power package lay up proce-
dures. Be sure to add an appropriate amount of Gasoline Stabilizer to the portable tank.
3 Flush the cooling system.
4 Change the oil and oil filter.

Table of Contents

Related product manuals