Emergency Starting
If the starter rope breaks or the rewind starter fails, use the spare starter rope
(provided) and follow this procedure.
!
WARNING
The neutral‑speed‑protection device is inoperative when starting the engine
with the emergency starter rope. Set the engine speed at idle and the gear
shift in neutral to prevent the outboard from starting in gear.
1. Shift the outboard to the neutral (N) position.
2. Disconnect the linkage from the rewind starter assembly.
a - Rewind starter assembly
b - Linkage
3. Remove the three 10 mm screws and rewind starter assembly.
a - 10 mm screw (3)
b - 10 mm wrench ‑ provided with
outboard
OPERATION
eng 29
To Next Page
Loading...
