Spark Plug Inspection and Replacement
!
WARNING
Damaged spark plug boots may emit sparks that can ignite fuel vapors under
the engine cowl, resulting in serious injury or death from a fire or explosion.
To avoid damaging the spark plug boots, do not use any sharp object or
metal tool to remove the spark plug boots.
1. Remove the spark plug boot. Twist the rubber boot slightly and pull off.
2. Remove the spark plug to inspect. Replace spark plug if electrode is worn
or the insulator is rough, cracked, broken, blistered, or fouled.
3. Set the spark plug gap to specification.
Spark Plug
Spark plug gap 0.9 mm (0.035 in.)
4. Before installing spark plug, clean off any dirt on the spark plug seat.
Install plug finger‑tight, and then tighten 1/4 turn or torque to
specifications.
Description
Nm lb‑in. lb‑ft
Spark plug 27 – 20
MAINTENANCE
38 eng
To Next Page
Loading...
