!
CAUTION
Failure to release pressure from the fuel system will result in fuel spraying
out, which can cause a fire or explosion. Allow the engine to cool completely
and release all fuel pressure before servicing any part of the fuel system.
Always protect eyes and skin from pressurized fuel and vapors.
GEN III MODELS
a - Cool Fuel Module
b - Cool Fuel Module
harness
c - Filter cap
d - Filter assembly
retaining screw
e - Fuel filter element
f - Filter cup
g - Cool Fuel Module filter
reservoir
h - O‑ring
Removal
1. Allow the engine to cool down.
NOTE: Mercury MerCruiser recommends that the engine be shut off for 12
hours prior to filter removal.
2. Close the fuel supply valve, if equipped.
3. Disconnect the Cool Fuel Module harness from the engine wiring harness.
4. Turn the key switch to the start position and allow the starter to operate
for five seconds.
5. Turn the key switch to the off position.
d
a
b
c
e
f
g
h
8837
MAINTENANCE
eng 79
To Next Page
Loading...
