EasyManuals Logo

Mercury 80 User Manual

Mercury 80
141 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
6. If the oil level is below the operating range (cross hatched region), remove
the oil filler cap and add approximately 500 ml (16 oz) of the specified
outboard motor oil. Allow a few minutes for the added oil to drain to the oil
sump and check the level on the dipstick. Repeat the process until the oil
level is on the operating range (cross hatched region). Do not try to fill to
the upper end of the operating range (cross hatched region).
53755
IMPORTANT: Inspect oil for signs of contamination. Oil contaminated with
water will have a milky color to it; oil contaminated with fuel will have a strong
fuel smell. If contaminated oil is noticed, have the engine checked by your
dealer.
7. Push the dipstick back in all the way.
8. Install the oil fill cap hand‑tight.
9. Install the top cowl.
FUEL AND OIL
48 eng

Table of Contents

Other manuals for Mercury 80

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 80 and is the answer not in the manual?

Mercury 80 Specifications

General IconGeneral
SteeringRemote
Shaft Length20 in (508 mm)
Gear Ratio2.07:1
Horsepower80 hp
Full Throttle RPM Range5000-6000 RPM
Bore x Stroke3.15 x 3.15 in (80 x 80 mm)

Related product manuals