2. Remove the spark plugs to inspect. Replace spark plug if
electrode is worn or the insulator is rough, cracked, broken,
blistered, or fouled.
Spark Plug
Spark plug gap 1.0 mm (0.040 in.)
4. Before installing spark plugs, clean off any dirt on the spark
plug seats. Install plugs finger‑tight, and then tighten 1/4 turn
or torque to specifications.
Description
Nm lb‑in. lb‑ft
Spark plug 27 20
Timing Belt Inspection
1. Inspect the timing belt and have it replaced by an authorized
dealer if any of the following conditions are found.
To Next Page
Loading...
