EasyManuals Logo

Mercury 9.9 Service Manual

Mercury 9.9
149 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Page ii 90-827242R02 FEBRUARY 2003
It is important to note, during any maintenance procedure replacement fasteners must have
the same measurements and strength as those removed. Numbers on the heads of the
metric bolts and on the surfaces of metric nuts indicate their strength. American bolts use
radial lines for this purpose, while most American nuts do not have strength markings.
Mismatched or incorrect fasteners can result in damage or malfunction, or possibly personal
injury. Therefore, fasteners removed should be saved for reuse in the same locations
whenever possible. Where the fasteners are not satisfactory for re-use, care should be
taken to select a replacement that matches the original.
Cleanliness and Care of Outboard Motor
A marine power product is a combination of many machined, honed, polished and lapped
surfaces with tolerances that are measured in the ten thousands of an inch/mm. When any
product component is serviced, care and cleanliness are important. Throughout this
manual, it should be understood that proper cleaning, and protection of machined surfaces
and friction areas is a part of the repair procedure. This is considered standard shop practice
even if not specifically stated.
Whenever components are removed for service, they should be retained in order. At the
time of installation, they should be installed in the same locations and with the same mating
surfaces as when removed.
Personnel should not work on or under an outboard which is suspended. Outboards should
be attached to work stands, or lowered to ground as soon as possible.
We reserve the right to make changes to this manual without prior notification.
Refer to dealer service bulletins for other pertinent information concerning the products
described in this manual.

Other manuals for Mercury 9.9

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 9.9 and is the answer not in the manual?

Mercury 9.9 Specifications

General IconGeneral
Cylinders2
Fuel TankExternal
Full Throttle RPM Range5000 - 6000 RPM
Fuel Induction SystemCarbureted
Alternator Amp6 amp
Horsepower9.9 hp
StartingManual
Shaft Length15 in, 20 in
SteeringTiller

Related product manuals