Mercury 90-895201 204 - TROLL CONTROL OPERATION; Setting and Adjusting Troll Speed; Methods to Disengage Troll Control

12
TROLL CONTROL
0
TROLL
+
TROLL
–
TROLL
+
TROLL
–
Speedometer
Tachometer
Actual Speed
Set Speed
Actual Speed Set Speed
a
b
1
2
3
4
5
6
7
0
80
To Set Troll Control
1. With the engine running, shift engine into gear. Set engine speed
at idle.
2. Push in the
TROLL
+
or
TROLL
–
button to bring up the troll control dis-
play screen.
3. Press
MODE
to engage (turn on) the troll control.
4. Use the
TROLL
+
TROLL
–
buttons to set the desired speed. Use (+)
to increase speed and (–) to decrease speed.
5. If you set troll control to a higher speed than the troll rpm can bring
the boat to, the TARGET SPEED TOO FAST (a) message will ap-
pear. Reduce troll speed.
6. If you set troll control to a slower speed than the troll rpm can bring
the boat to, the TARGET SPEED TOO SLOW (b) message will ap-
pear. Increase troll speed.
To Get Out of Troll Control
There are three ways to turn off the troll control:
• Press the
MODE
button when in the troll display screen.
• Move the throttle to a different speed.
• Shift engine into neutral.