5
AUTO-DETECTION ENGINE FUNCTION
On first time power up of gauge or after a “Master Reset”, gauge will
display “Auto detect”. Upon pressing the mode button, gauge will au-
tomatically determine engine type. This will preset the data monitoring
screens accordingly. The intention is to make initial setup easier.
If the gauge shows a warning of “No Starboard Engine” or “Multiple
Starboard Engines”, engine location must be properly selected (Port
and Stbd) at the engine using a Mercury engine diagnostic tool. “Mas-
ter Reset” and “Auto detect” again. (Refer to “Master Reset”).
System tach and speed come standard with an “Engine Auto–
detection Screen” this screen lets the gauge on its initial power up
automatically detect which engine type you are using and configure
the gauge to match that vessel type.
To Next Page
Loading...
