18
TACHOMETER CALIBRATION
Quick Cal Calibration
Quick Cal – This calibration is for setting lighting and contrast.
1. Press in the
MODE
and
TROLL
+
buttons for up to 2 seconds to get
to Quick Cal screen.
2. Press
MODE
to advance through the calibration selections.
CAL 1 Tachometer Calibration
Cal 1 – This calibration lets you turn on and off the system screens.
NOTE:Screens may vary depending upon the version of the gauge.
1. Press in the
MODE
and
TROLL
+
buttons and hold for approxi-
mately 7 seconds until you see the Cal 1 screen.
2. Press
MODE
to advance through the calibration selections.
[NO]
REMOTE SCREENS?
[YES][SAVE]
If yes is selected, then screen changes
made on this SC1000 tach will effect
any other SC1000 tach in the system.
NOTE: All tachs will need to have this screen
turned to “Yes” for this function to work.
[NO]
REMOTE LCD LIGHT?
[YES]
[SAVE]
If yes is selected, then lighting levels
made on this SC1000 tach will effect
any other SC1000 tach in the system.
NOTE: All tachs will need to have this screen
turned to “Yes” for this function to work.
REMOTE LCD CONTRAST?
[YES]
[NO]
[SAVE]
If yes is selected, then contrast levels
made on this SC1000 tach will effect
any other SC1000 tach in the system.
NOTE: All tachs will need to have this screen
turned to “Yes” for this function to work.
[NO]
TRIM POPUP?
[YES][SAVE]
Do you want power trim display screen
to pop up momentarily when you trim
the engine?
(continued on next page)
To Next Page
Loading...
