30
SPEEDOMETER CALIBRATION
CAL 2 Speedometer Calibration
CAL 2 – This calibration lets you configure the system sensor inputs.
NOTE:Screens may vary depending upon the version of the gauge.
1. Press in the
MODE
and
TROLL
+
buttons and hold for approximately
10 seconds for calibration2 (Cal2) screen.
2. Press
MODE
to advance through the calibration selections.
EXTERNAL SENSORS
[EDIT]
[SKIP]
This lets you enable or disable external
sensor inputs.
AIR TEMP?
[NO]
[YES]
[SAVE]
Are you using an air temp sensor?
GPS?
[NO]
[YES]
[SAVE]
Do you have a GPS sensor installed?
USE GPS SPEED?
[NO]
[YES]
[SAVE]
Use the GPS input to drive the speed
display?
(continued on next page)
To Next Page
Loading...
