7. Do not advance the neutral fast idle speed feature on the remote control. The enrichener system will
automatically increase engine speed for starting and warm-up.
8. Turn ignition key to the "start" position. If engine fails to start in ten seconds, return key to "on" position, wait
30 seconds and try again.
NOTE: Starting Flooded Engine - Advance the neutral fast idle speed feature on the remote control to the full fast
idle speed position and continue to crank the engine for starting. Immediately start to reduce engine speed after
engine starts.
9. After engine starts, check for a steady stream of water flowing out of the water pump indicator hole.
IMPORTANT: If no water is coming out of the water pump indicator hole, stop engine and check cooling water
intake for obstruction. No obstruction may indicate a water pump failure or blockage in the cooling system. These
conditions will cause the engine to overheat. Have the outboard checked by your dealer. Operating the engine
while overheated will cause engine damage.
WARMING UP ENGINE
Before beginning operation, allow the engine to warm up at idling speed for 3 minutes.
To Next Page
Loading...
Need help?
General
