WARNING
When using emergency starter rope to start engine, the start in gear protection device is inoperative. Make sure
to set the outboard gear shift into neutral to prevent outboard from starting in gear. Sudden unexpected
acceleration could result in serious injury or death.
3. Turn the ignition key to "on" position.
WARNING
To prevent getting an electrical shock, do not touch any ignition component, wiring, or spark plug wire when
starting or running the engine.
WARNING
The exposed moving flywheel can cause serious injury. Keep your hands, hair, clothing, tools, and other objects
away from engine when starting or running the engine. Do not attempt to reinstall the flywheel cover or top cowl
when engine is running.
4. Place the starter rope knot into the flywheel notch and wind the rope clockwise around the flywheel.
5. Pull the rope slowly until resistance is felt.
6. Remove rope and reposition the rope knot in one of the flywheel notches within the approximate location.
Wind the rope approximately 3/4 of one turn clockwise around flywheel. Do not exceed one turn.
To Next Page
Loading...
Need help?
General
