131
D Install new anode. Tighten screws securely.
E Reinstall propeller. See Propeller Installation for proper tighten-
ing.
8 Bearing Carrier Anode - is located in front of the propeller,
between the front side of the propeller and the gear housing. Refer
to Propeller section in this manual for propeller removal and
installation.
9 Gear Housing Anode (Bravo Two and Three) - is located in the
splash plate, just above the propellers.
CA965
In addition to the corrosion protection devices, the following steps
should be taken to inhibit corrosion:
IMPORTANT: Corrosion damage that results from the improper
application of anti-fouling paint will not be covered by the
limited warranty.
1 Painting Boat Hull or Boat Transom: Anti-fouling paint may be
applied to boat hull and boat transom
but you must observe the
following precautions:
IMPORTANT: DO NOT paint anodes or MerCathode System
reference electrode and anode, as this will render them
ineffective as galvanic corrosion inhibitors.
IMPORTANT: If anti-fouling protection is required for boat hull
or boat transom, copper or tin base paints, if not prohibited by
law, can be used. If using copper or tin based anti-fouling
paints, observe the following:
To Next Page
Loading...
