TILLER HANDLE TILT FRICTION ADJUSTMENT
The tiller handle pivot bolt can be adjusted to increase or decrease the amount
of effort needed to move the tiller handle up and down. Loosen the jam nut on
the end of the pivot bolt and tighten or loosen the pivot bolt to obtain the
desired friction setting on the tiller handle. Hold the pivot bolt from turning and
tighten the jam nut to the specified torque.
a - Pivot bolt and jam nut
Description Nm lb‑in. lb‑ft
Tiller handle tilt friction jam nut 47 – 35
To Next Page
Loading...
